Also make sure that there is no conduction signal in position «turned off» - «OFF».
Pic. 7.58. Checking the central locking switch on the front door on the driver's side
If the conductivity does not match the data in the table, replace the switch.
Standard check
Check the operation of the driver's door lock electric drive in the positions indicated in the table.
Connect the positive battery terminal to the «4» and negative terminal - with output «1», make sure that the latch of the lock has moved to the position «LOCK». Reverse the polarity of the connector pins and make sure that the latch of the lock has moved to the position «UNLOCK».
If the operation of the actuator is not as described, replace the lock assembly.
Standard check
Check for continuity between the connector pins and the door lock switch on the driver's side in the positions shown in the table.
Pic. 7.59. Checking the operation of the electric drive of the driver's door lock
If the conductivity does not match the data in the table, replace the lock assembly.