Removing
Remove the rear wheel.
Pic. 3.151. Disconnecting the rear flexible hose
Loosen the bolt and disconnect the rear flexible hose (pic. 3.151).
Pic. 3.152. Removing the disc brake caliper
Remove 2 bolts and remove disc brake caliper (pic. 3.152).
Install the support under the brake caliper.
Remove the rear disc.
Disconnect the skid control sensor wire.
Pic. 3.153. Removing the rear wheel hub
Remove 4 bolts and remove the rear wheel hub (pic. 3.153).
Pic. 3.154. Removing and installing the skid control sensor
Remove, check and install the skid control sensor (pic. 3.154).
Installation
Install the rear wheel hub and secure it with 4 bolts.
Tightening torque: 80 Nm.
Install the skid control sensor wire.
Check bearing clearance and wheel hub runout (see above: «Vehicle check»).
Install the rear disc.
Install the disc brake caliper and secure it with 2 bolts.
Tightening torque: 61.8 Nm.
Install rear flexible hose with bolt.
Tightening torque: 18.8 Nm.
Install the rear wheel.
Tightening torque: 103 Nm.
Check and adjust rear wheel alignment.
Check ABS speed sensor signal.