Drain the oil from the manual transmission in the final drive (Manual Transmission).
Remove the front wheel.
Pic. 3.163. Disconnection of the deformed part of the flange of the front wheel hub nut
Using special tool 09930-00010 and a hammer, bend the deformed part of the collar of the front wheel hub nut (pic. 3.163).
Attention! Bend the deformed part of the shoulder completely, otherwise the threads on the drive may be damaged.
Loosen the front wheel hub nut while depressing the brake pedal.
Pic. 3.164. Disconnecting the front anti-roll bar from the front suspension strut
Unscrew the nut, disconnect the front anti-roll bar from the front suspension shock absorber (pic. 3.164).
Note. If the ball joint pin turns with the nut, use a socket wrench (6 mm), to fix your finger.
Remove the speed sensor wire clamp.
Pic. 3.165. Disconnecting the speed sensor wire clamp
Unscrew the bolt, disconnect the sensor wire and the front flexible hose No. 1 from the front suspension shock absorber strut (pic. 3.165).
Pic. 3.166. Disconnecting the speed sensor from the steering knuckle
Remove the bolt, disconnect the speed sensor from the steering knuckle (pic. 3.166).
Remove the cotter pin and nut.
Pic. 3.167. Disconnection of steering draft from a rotary fist
Using special tool 09628-62011, disconnect the tie rod from the steering knuckle (pic. 3.167).
Pic. 3.168. Disconnecting suspension arm No. 1 from the lower ball joint
Remove the bolt and 2 nuts and separate the #1 suspension arm from the lower ball joint (pic. 3.168).
Using a nylon hammer, disconnect the front wheel drive assembly from the wheel hub.
Attention! Be careful not to damage the boot and speed sensor rotor.
Remove the front wheel drive assembly.
Pic. 3.169. Removing the front wheel drive assembly
Using the special tool 09520-01010, 09520-24010, remove the front wheel drive assembly (pic. 3.169).
Attention! Be careful not to damage the seal.
Pic. 3.170. Removal of a lock ring of the bearing of a power shaft
Using pliers, remove the driveshaft bearing snap ring (pic. 3.170).
Turn away a bolt and remove the right drive of a forward wheel in gathering.
Lock the front wheel hub.
Attention! The hub bearing can be damaged by the weight of the vehicle when the vehicle is moved with the drive shaft removed.
Pic. 3.171. Fixing the hub relative to the steering knuckle using a special tool
Therefore, if you need to move the car on wheels, first fix the hub relative to the steering knuckle using a special tool 09608-16042 (pic. 3.171).