Note. The adjustment procedures for the left and right front doors are the same.
Pic. 8.8. Centering and standard bolts
Note. Due to the fact that when adjusting the doors, you cannot use the centering bolts that secure the door hinges, replace them with bolts with washers (standard bolts).
Pic. 8.9. Tolerances for gaps in doorways
Inspect the front doors and check that the size of the gaps in the doorways is within the tolerances indicated in Figure 8.9.
Note. The tolerances are given in mm.
If the gaps differ from the specified, adjust the position of the doors.
Pic. 8.10. Adjusting the longitudinal-vertical position of the front door
Using the special tool 09812-00010, loosen the door hinges and adjust the position of the doors in the vertical and longitudinal positions (pic. 8.10).
Tightening torque of adjusting bolts: 26 Nm.
Pic. 8.11. Adjusting the transverse-vertical position of the front door
If necessary, also adjust the transverse-vertical position of the doors (pic. 8.11).
Tightening torque of adjusting bolts: 26 Nm.