Note. The procedures for adjusting the left and right rear doors are the same.
Pic. 8.13. Tolerances for gaps in doorways
Inspect the rear doors and check that the size of the gaps in the doorways is within the tolerances indicated in Figure 8.13.
Note. The tolerances are given in mm.
If the gaps differ from the specified, adjust the position of the doors.
Disconnect the rear door sill trim fastener closest to the B-pillar.
Disconnect the front door sill trim fastener closest to the B-pillar.
Remove the center pillar trim.
Pic. 8.14. Adjusting the longitudinal-vertical position of the rear door
Loosen the door hinges and adjust the position of the doors in the vertical and longitudinal positions (pic. 8.14).
Tightening torque of adjusting bolts: 26 Nm.
Pic. 8.15. Adjusting the transverse-vertical position of the rear door
If necessary, also adjust the cross-vertical position of the doors (pic. 8.15).
Tightening torque of adjusting bolts: 26 Nm.