Contents: Adjustment ↓ Replacement ↓
Adjustment
When moving the gear selector lever from neutral to other positions, it should move smoothly and lock firmly. At the same time, the lever position indicator should indicate the correct lever position. If the indicator does not show the correct lever position, adjust the gear selector cable as follows.
1. Raise the car and secure it on stands. Remove the mudguards.
2. Loosen the nut securing the gear selector cable pivot bolt to the gear selector lever of the transmission.
3. Move the gear selector lever all the way down, then move it back 2 positions and set it to neutral.
4. Set the gear selector lever inside the vehicle to neutral position.
5. Tighten the nut securing the shift cable pivot bolt to the gearshift lever.
6. Check the operation of the gearbox in each position of the gear selector lever. When starting the engine, the starter should only operate in the PARK or NEUTRAL position of the gear selector lever.
[The original is published on the website: www.toyotaman.ru]
Replacement
 |  |
1. Remove the gear selector cable from the lever on the transmission.
2. Remove the C-clamp and disconnect the cable housing from the bracket.
3. Unscrew the bolts securing the gear selector cable housing retainer.
4. Remove the center console.
 |  |
5. Remove the shift cable housing retaining C-clip at the base of the shift lever.
6. Remove the bracket, remove the pin and disconnect the gear selector cable from the gear selector lever.
7. Remove the gear selector cable from underneath the vehicle.
8. Installation is carried out in the reverse order of removal.