Exterior mirrors
1. On vehicles with power mirrors, remove the door trim and water shield (see subsection 11.16.).
2. Pry and remove the mirror trim from the inside of the door.
3. Disconnect the motor connector.
4. Remove the three screws securing the mirror. Trace the wiring route and disconnect the door mirror motor connector. Remove the mirror.
5. Installation is carried out in the reverse order.
Interior mirror
1. Insert a screwdriver blade wrapped with tape into the groove of the base of the mirror leg and push out the U-shaped spring pin that holds the mirror leg in the base (the screwdriver should go about 18 mm).
2. When installing the mirror, insert the spring if it was removed. Insert the mirror into the base and press down.
3. If the mirror mounting plate has fallen off the windshield, then it should be glued with special glue.