2. Check tire pressure.
Depending on the configuration, operating conditions and the quality of the tires installed, the tire pressure in the cold state is:
- In the front - 2.0-2.2 kPa
- In the rear - 1.9 kPa
Note: When carrying heavy loads, increase the rear tire pressure by approximately 0.5 kPa.
3. Check wheel runout.
- Runout - no more than 3.0 mm
4. Check up a condition and reliability of fastening of details of a suspension bracket.
5. Check up a condition of steering drafts.
6. Check up correct work of shock-absorbers.
7. Measure the installation height of the vehicle.
(); for 4WD models.
*1: for 4WD models (ZS-T) since 1996 and models since the beginning of 1995
Note.
- Front Suspension: Measure from the ground to the center of the front lower arm mounting bolt.
- Rear Suspension: Measure from the ground to the center of the trailing arm mounting bolt. Before checking the wheel alignment, it is necessary to adjust the installation height in accordance with established standards. If the installation height does not meet the established standards, then you should try to correct it by pushing the body down or lifting the body up.