Removal and installation
Note: Installation is performed in the reverse order of removal. After installation, check the front wheel alignment angles.
1. Jack up the car, remove the front wheels.
- Tightening torque - 105 Nm
2. Unscrew the nuts, remove the outer washers and bushings.
Note: Perform final tightening of the nut after the suspension has stabilized.
- Tightening torque - 216 Nm
3. Loosen the bolts, remove the bushing holders and bushings.
- Tightening torque - 86 Nm
Anti-roll bar.
1 - engine protection cover,
2 - sleeve holder,
3 - bushing,
4 - anti-roll bar,
5, 8 - washer,
6, 7 - bushing.
(The publication is taken from the website: «toyotaman.ru»)
4. Remove the anti-roll bar, then remove the inner bushings and washers.
