If the toe-in does not meet the specified conditions, then adjust the toe-in.
a) Measure the distance shown in the figure for the left and right lower control arms of suspension No.2.
- The difference in measurements is no more than 3 mm
(View the full text on the portal Toyotaman.ru)
If the difference in measurements between the right and left is greater than the specified value, perform the adjustment procedure below.
b) Loosen the bolts.
c) When adjusting the toe-in, turn the eccentrics by the same amount.
Toe-in when adjusted: B-A-4±1 mm
Note:
- try to set the average value of the convergence value.
- turn the eccentrics no more than four divisions from the central position.
d) Tighten the bolts.
- Tightening torque - 115 Nm
3. Check the rear wheel alignment.
- Nominal camber - -1°05' +45'