If the toe-in does not meet the specified conditions, then make adjustments.
a) Measure the distance shown in the figure for the left and right lower control arms of suspension No.2.
- The difference in measurements is no more than 3 mm
If the difference in measurements between the right and left is greater than the specified value, perform the adjustment procedure below.
[The original article is on the portal: toyotaman.ru]
b) Loosen the bolts.
c) When adjusting the toe-in, turn the eccentrics by the same amount.
Toe-in when adjusting: B - A = 4 ±1 mm
Note: Try to set the toe value to the average value.
d) Tighten the bolts.
- Tightening torque - 115 Nm
3. Check the rear wheel alignment
- Nominal camber - -0° 40' ±45'
Note: the camber of the rear wheels is not adjustable, therefore if this value does not correspond to the specified conditions, it is necessary to check the condition and replace faulty suspension parts.