Contents: Removal ↓ Replacing the hub bolt ↓
Removal
Note: Installation is performed in the reverse order of removal. After installation, check the operation of the speed sensors (ABS).
1. Jack up the car, remove the rear wheel.
- Tightening torque - 105 Nm
2. Loosen the bolt and remove the brake hose clamp from the strut.
- Tightening torque - 30 Nm
3. Remove the caliper and brake disc.
a) Unscrew the two bolts securing the caliper bracket.
- Tightening torque - 47.5 Nm
b) Hang the support on the wire.
c) Remove the brake disc.
4. Check the bearing axial clearance and hub runout.
a) Using a dial indicator, check the bearing axial clearance.
- Maximum gap - 0.05 mm
If the clearance is not within the norm, replace the bearing.
Rear wheel hub (2WD models)
1 - support,
2 - brake drum,
3 - brake disc,
4 - rear wheel hub,
5 - hub bolt,
6 - O-ring seal.
b) Using an indicator, check the hub runout.
- Maximum runout - 0.07 mm
If the runout is not within the norm, replace the hub and bearing.
5. Remove the rear wheel hub.
a) Unscrew the four bolts and remove the rear wheel hub.
- Tightening torque - 82 Nm
b) Remove the O-ring.
Installation Note: Apply grease to the O-ring.
Replacing the hub bolt
Note: See the relevant section in the chapter "Front suspension".