Pic. 5.46. Installation of the discharge pipeline
Note. Install the pressure line stopper so that it touches the front bracket, as shown in Figure 5.46, and tighten the bypass valve.
Install the pump assembly with the discharge pipeline.
Install the power steering pump drive belt.
Pic. 5.47. Bolt tightening «A»
Using a torque wrench with a foot length of 345 mm, tighten the bolt «A» (pic. 5.47).
Tightening torque using a special tool and a torque wrench 345 mm long: 29 Nm.
tighten bolt «IN».
Tightening torque: 43 Nm.
Note. The tightening torque will be correct if the special tool is parallel to the torque wrench.
Connect the connector to the fluid pressure sensor.
Install two bushings, two retainer plates and tighten the bolt.
Tightening torque: 10 Nm.
Connect return hose.
Install the right protective apron and tighten the two bolts.
Bleed the power steering system.