Pic. 2.79. Installing the intake camshaft sprocket: 1 - locking pin; 2 - notch
Hold the sprocket in such a position that the groove in it is slightly to the left of the camshaft locating pin (shaft side). Install the sprocket onto the camshaft. Lightly press the sprocket and turn it counterclockwise. Make sure there is no visible gap between the sprocket and the end of the camshaft. While holding the shaft with a wrench, tighten the mounting bolt to a torque of 54 Nm. Make sure the WT drive moves clockwise and is locked in the correct position by the locking pin (pic. 2.79).