- No. 1 - 30 Nm (301 kg cm);
- No. 2 - 30 Nm (301 kg cm);
- No. 3 - 9 Nm (92 kg cm).
Pic. 2.86. Installing the camshaft bearing caps
Attention! Do not turn the camshaft.
Attention! Remove bearing caps. Measure the width of the deformed plastic gauges at their widest point and calculate the backlash.
Radial play
Standard (inlet):
- neck No. 1–0.007–0.038 mm;
- the rest - 0.025–0.062 mm.
Standard (release):
- neck No. 1–0.015–0.054 mm;
- the rest - 0.025–0.062 mm.
Limit:
- neck No. 1–0.070 mm;
- the rest - 0.100 mm.
If the play is greater than the limit, replace the camshaft. Replace bearing caps and cylinder head if necessary.
Remove any remaining plastic gauges. Replace front bearing if necessary.
Note. Use liners of the same size group indicated on the bearing and cylinder head.
Bearing bed diameter:
- label «1» - 40.000–40.008 mm;
- label «2» - 40.009–40.017 mm;
- label «3» - 40.018–40.025 mm.
The diameter of the camshaft journal is 35.971–35.985 mm.
Liner thickness:
- label «1» - 2.000–2.004 mm;
- label «2» - 2.005–2.008 mm;
- label «3» - 2.009–2.012 mm.