Pic. 2.304. Combination of labels of gear wheels of a drive of a camshaft
Apply a layer of engine oil to the end thrust surfaces of the camshaft. Engage the gears of the camshaft drive of the exhaust and intake valves, aligning the alignment marks with each other (two dots) on gears. Install the intake camshaft to the cylinder head (pic. 2.304).
Pic. 2.305. Bearing cap markings
Install the bearing caps in accordance with the markings on their housings (pic. 2.305).
Pic. 2.306. The order of tightening the bolts of the left bearing caps
Apply a light coat of engine oil to the threads and under the heads of the bearing cap bolts. Establish and evenly tighten ten bolts of fastening of covers of bearings in several passes with the moment of an inhaling of 16 Н·м in the sequence shown in drawing 2.306.
Turn away a technological bolt.
Rotate the camshaft and place the cams with the working projections up, check and adjust, if necessary, the clearance in the valve drive.
Pic. 2.307. Places for applying sealant to segment plugs: 1 - sealant
Remove old sealing material. Apply sealant to the segment plugs, as shown in Figure 2.307.
Pic. 2.308. Locations for segment plugs
Install four segment plugs in the cylinder heads (pic. 2.308).