Pic. 2.300. Combination of labels of gear wheels of a drive of a camshaft
Apply a layer of engine oil to the end thrust surfaces of the camshaft. Install the exhaust camshaft 90°from the position where the timing marks line up (1 point) on the cylinder head (pic. 2.300).
Pic. 2.301. Installing the oil seal on the camshaft
Apply grease to the new oil seal. Install the oil seal on the camshaft (pic. 2.301).
Pic. 2.294. Sealing locations: 1 - sealant
Remove the old sealing material from the bearing cap. Apply sealant to bearing cap #1 (see fig. 2.294).
Pic. 2.302. Bearing cap markings
Install the bearing caps in accordance with the markings on their housings (pic. 2.302).
Pic. 2.303. The order of tightening the bolts of fastening of the right bearing caps
Apply a light coat of engine oil to the threads and under the heads of the bearing cap bolts. Establish and evenly tighten ten bolts of fastening of covers of bearings in several passes by the moment of an inhaling of 16 Н·м in the sequence shown in drawing 2.303.