2. Open the front door. Using a screwdriver blade as a lever, remove the decorative trim of the inner door opening handle.
3. On manual window models, close the window completely and mark the position of the window handle. Release the retaining clip and remove the handle. The clip is released by inserting a clean cloth between the handle and the door trim and, pulling the cloth opposite the ends of the clip, hook the clip and release it. In this case, it is necessary to pull the handle towards you so that after releasing the clip, it comes off the splines of the window regulator.
 |  |
4. Remove the door trim to door fastening clips located around the perimeter of the door trim.
5. Remove the screws securing the door armrest.
6. Using a wide-blade screwdriver, pry the door trim away from the door.
7. After separating the door trim from the door, disconnect the electrical connectors and remove the door trim from the vehicle.
8. If necessary, remove the protective film from the door.
9. Installation is carried out in the reverse order of removal.