The overwrite mode is used to erase all previously registered codes and register only new codes. This mode is used when replacing the transmitter or receiver of the door control unit with a new one.
The inhibit mode is used to clear all registered codes and cancel the wireless door lock control. Use this mode when the transmitter is lost.
Confirmation mode is used to confirm how many codes have already been registered before registering an additional code.
For correct registration of the code, the following conditions must be met:
- the key is not inserted into the ignition lock cylinder;
- driver's door OPEN (other doors CLOSED);
- the driver's door is unlocked.
Follow the steps below.
Insert and remove the key from the ignition lock cylinder twice within 5 seconds.
Close and open the driver's door twice within 40 seconds. Then insert the key into the ignition lock cylinder and remove it.
Close and open the driver's door twice within 40 seconds. Then insert the key into the ignition lock cylinder and close the door.
Turn the ignition switch from position «LOCK» into position «ON» and back within about one second 1 to 5 times, depending on the selected mode. Then remove the key from the ignition lock cylinder.