Using solvent, clean the contact and seal surfaces.
Note. Do not use a solvent that will attack painted surfaces.
Pic. 2.375. Places for applying sealant to the contact surface of the upper part of the oil pan
Apply sealant to the contact surface of the top of the oil pan, as shown in Figure 2.375.
Install the upper part of the oil pan and tighten the two nuts and seventeen bolts to the following torque:
- head 10 mm - 8 Nm;
- head 12 mm - 20 Nm;
- head 14 mm - 37 Nm.
Installing the lower crankcase cover
Install the lower flywheel housing cover and secure it with two bolts with a tightening torque of 8 Nm.
Install the oil receiver, tighten the three nuts with a tightening torque of 8 Nm.