Pic. 2.373. Places for applying sealant to the contact surface of the oil pump
Remove any remaining sealing material from the contact surfaces of the oil pump. Using solvent, clean the contact and seal surfaces. Apply a new sealant to the contact surface of the oil pump, as shown in Figure 2.373.
After applying the sealant, the mating parts must be assembled within the time specified in the instructions for use of the sealant. Otherwise the material must be removed and the sealant reapplied.
Pic. 2.374. Oil pump installation
Engage the grooves of the inner gear of the oil pump rotor with splines on the crankshaft and install the oil pump, as shown in Figure 2.374.
Tighten the nine oil pump mounting bolts in several passes to the following torque:
- head 10 mm - 8 Nm;
- head 12 mm - 20 Nm.