Remove the lower engine guards.
Remove the automatic transmission drain plug and drain the fluid. After replacing the drain plug gasket, install it in place by tightening with a tightening torque of 49 Nm.
Remove front halts assy (see below).
Pic. 3.126. Removal of an epiploon of a forward cover of a case of the main transfer
Using the special tool 09308-00010, remove the oil seal of the front cover of the main gear housing (pic. 3.126).
Pic. 3.127. Removal of an epiploon of a case of a transmission
Using the special tool 09308-00010, remove the gearbox housing oil seal (pic. 3.127).
Lubricate the sealing lip of the new oil seal with MP grease.
Pic. 3.128. Pressing in the oil seal of the front cover of the main gear housing
Using special tool 09608-10010 and a hammer, press in a new oil seal (pic. 3.128).
Pressing depth: (0±0,5) mm.
Attention! Be careful not to damage the seal lip.
Coat the lip of the new oil seal with MP grease.
Pic. 3.129. Pressing in the oil seal of the final drive housing
Using special tool 09608-32010 and a hammer, install a new oil seal (pic. 3.129).
Reassemble and install the remaining elements in the reverse order of removal.