Checking high voltage wires [Toyota Camry Vista-V40]

1. Disconnect the spark plug wires from the spark plugs by holding them only by the rubber caps. Improper handling of the wires can cause internal wire breaks.

2. Inspect the tips for electrical breakdown, cracks, conductive paths. Replace high-voltage wires if necessary.

3. Using an ohmmeter, check the resistance of each high voltage wire.

Maximum resistance is 25 kOhm per wire

Publication Reprinted from a web portal: toyotaman.ru

If the resistance exceeds the specified value, check the wire tips or replace the wires and/or distributor cap (integrated ignition unit).

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Mitrofanova Elena

Share information:

◀ Previous

Camry Vista V40: Maintenance

Next ▶

Checking the battery status
Checking the level of working fluid of the brake system and clutch
Checking the power steering fluid level
Checking and replacing oil in manual transmission and transfer case (4WD)
Checking the level and replacing the oil in the rear axle gearbox

Checking spark plugs
Checking the drive belt of the attachments
Checking and adjusting the ignition timing angle
Checking and adjusting the injection advance angle
Checking the idle speed (3S-FE, 4S-FE)