Contents: Examination ↓ Replacement ↓
Typical 4-cylinder engine mounts
1. Engine displacement control rod; 2. Rear engine mount; 3. Manual transmission; 4. Automatic transmission; 5. Collector mounting; 6. Front engine mount; 7. Engine bracket
Examination
1. Raise and support the front of the vehicle. Place a jack under the oil pan.
2. Inspect the rubber shock absorbers of the supports for wear and damage; replace them if necessary.
3. Check that the support bolts are tightly tightened.
4. Check that the bearings themselves are not worn out.
Replacement
1. Disconnect the negative battery cable. Raise and support the front of the vehicle.
2. To remove the right support, unscrew the nut and remove the through bolt.
3. Unscrew the nuts securing the support to the bracket and remove the support.
4. To remove the rear support, remove the three rubber plugs and unscrew the support nuts.
5. To remove the front support, loosen the nut that secures it to the engine bracket and remove the three bolts that secure the support to the body.
6. Installation is carried out in reverse order.