Pic. 4.33. Nuts of fastening of a rack of the stabilizer of cross stability
Remove the 2 mounting nuts and disconnect the left and right anti-roll bars from the lower arm (pic. 4.33).
Attention! If the ball joint shaft turns with the nut, use a hex wrench (by 6 mm), to hold the stand.
Remove the front suspension frame damper.
Pic. 4.34. Fastening of a collar of a damper of the stabilizer of cross-section stability
Loosen the 2 clamp bolts and remove the anti-roll bar damper (pic. 4.34).
Remove the anti-roll bar. Take it off the left side.
Pic. 4.35. Check of the moment of scrolling of the spherical hinge of a rack of the stabilizer
Check the moment of scrolling of the ball joint of the stabilizer bar (pic. 4.35).
Using a torque wrench, turn the nut continuously (one revolution in 2–4 s) and take the reading at the fifth turn.
Scroll torque: 0.05–1.96 Nm.
Pic. 4.36. Installation diagram of the anti-roll bar damper
Install the anti-roll bar damper. Install it with the back facing the inside of the stabilizer (pic. 4.36).
Install other parts in the reverse order of removal.