Location of direction indicator/hazard warning flasher
The direction indicator/hazard warning flasher (indicated by the arrow) is mounted on a plastic bracket on the engine compartment bulkhead behind the mounting block.
Check and replace
1. Normal operation of the breaker is accompanied by clicking sounds. If one of the turn signals does not work and clicking sounds are not heard, then the lamp should be checked.
Warning: If the frequency of interruptions suddenly decreases, the cause is a burnt-out lamp.
2. If both indicators do not work, the cause is a blown fuse, a faulty breaker, switch, or loose contacts. If the fuse is blown, check for a short circuit in the wiring, and only after this check install a new fuse.
3. To replace the breaker, remove it from the bracket and disconnect the connector.
4. Make sure the new breaker is exactly the same as the one being replaced.
5. Installation is carried out in reverse order.
(View the original source on the website: toyotaman)