Pic. 2.163. Places for applying sealant to the surface of the pallet: 1 - sealant
Remove the old sealant from the surfaces of the sump and crankcase, being careful not to damage the contact surfaces. Clean the contact surfaces with solvent. Apply sealant to the surface of the pallet, as shown in Figure 2.163.
The hole in the tube should allow the diameter of the extruded sealant to be 4 mm. Parts must be connected within the time specified in the instructions for use of the sealant. Otherwise, remove the sealant again and lay a new one.
At the end of the application of sealant, the nozzle of the tube must be removed and cleaned of traces of sealant, and the tube must be tightly closed.
Pic. 2.164. Oil pan bolts and nuts
Install the oil pan and tighten the two nuts and twelve oil pan bolts to 9 Nm (pic. 2.164).
Screw in the drain plug with a tightening torque of 25 Nm.