Pic. 2.165. Places for applying sealant to the surface of the coolant pump
Before installation, clean the contact surfaces of the coolant pump from the old sealant. Apply new sealant to pump lip (layer thickness 2–2.5 mm) (pic. 2.165).
Note. Remove excess sealant. After installing the pump, do not start the engine for two hours.
Pic. 2.166. Bolts and nuts of fastening of the pump of a cooling liquid
Install the water pump housing by tightening the four mounting bolts and two nuts to a torque of 9 Nm (pic. 2.166).
Pic. 2.167. Installing the water pump pulley
With special tool 09960-10010 (09962-01000, 09963-00700) install the coolant pump pulley by tightening the four mounting bolts to a torque of 26 Nm (pic. 2.167).