Checking fluid pressure
1. Install the pressure gauges as shown in the figure.
1 - models with disc brakes,
2 - models with drum brakes.
Removing the pressure regulator.
1 - air filter,
2 - coolant temperature switch,
3 - retainer,
4 - bracket (manual transmission).
2. Remove air from the pressure gauges.
3. Pressurize the master cylinder and measure the pressure in the rear wheel cylinder.
If the results obtained do not match the data on the corresponding graphs, replace the regulator.
Models without ABS - SV40, SV43, CV40
Models with ABS - SV41, SV42, CV40