5S-FE engine balancer parts
1. Set the #2 balancer shaft marks as shown in the figure.
2. Then turn the balancer shaft so that the D mark is aligned with the pointer on the casing.
3. Using pliers, lock the #2 balancer shaft from turning.
4. Using a dial gauge, measure the play on the #1 balancer shaft.
5. Remove the dial indicator and rotate the #2 balancer shaft so that the E mark is aligned with the pointer. Install a dial gauge and re-measure the No. 1 balancer shaft play.
6. Remove the dial indicator and rotate the #2 balancer shaft so that the D mark is aligned with the pointer. Install a dial gauge and re-measure the #1 balancer shaft play. If the measured play in any case exceeds the allowable limits, it is necessary to have the balancer assembly repaired at a service station.