Contents: Removal ↓ Installation ↓
Attention! Cylinders are changed only in pairs per axle.
Removal
1. Raise the rear of the vehicle.
2. Remove the pads (see subsection 10.4. and subsection 10.7.).
3. Clean the wheel cylinder.
4. Unscrew the hydraulic drive nipple. The arrows indicate the wheel cylinder mounting bolts.
5. Loosen the cylinder mounting bolts.
6. Remove the cylinder and plug the pipe.
Installation
1. Install the cylinder, tighten the bolts by hand. Screw in the nipple and tighten the mounting bolts.
2. Tighten the nipple and install the shoes and drum.
3. Remove air from the hydraulic drive.
4. Install the wheel, lower the vehicle and check the brakes.