Contents: Removal ↓ Installation ↓
Front brake parts (for models with 4-cylinder engine)
1. Support; 2. Caliper bracket; 3. Seal; 4. Finger; 5. Rubber cover; 6. Brake shoe retainers (for cars with 5S-FE engine); 7. Brake shoe retainers (for cars with 1MZ-FE engine); 8. Anti-noise plates; 9. Internal noise-absorbing plate; 10, 13. Spring of the anti-noise plate; 11. Inner shoe; 12. Outer shoe; 14. Brake pad wear indicator (for cars with 1MZ-FE engine); 15. Cover; 16. Seal; 17. Finger; 18. Piston sealing ring; 19. Piston limiting ring; 20. Piston; 21. Brake bleed nipple
Front brake parts (for models with 6-cylinder engine)
1. Support; 2. Caliper bracket; 3. Disk; 4. Seal; 5. Finger; 6. Seal; 7. Rubber cover; 8. Brake shoe retainers; 9. Anti-noise plates; 10. Spring of the anti-noise plate; 11. Outer shoe; 12. Inner shoe; 13. Brake pad wear indicator; 14. Cover; 15. Finger; 16. External seal; 17. Piston limiting ring; 18. Piston; 19. Piston sealing ring; 20. Brake bleeder nipple
Rear brake parts
1. Seal; 2. Support; 3. Brake bleeder nipple; 4. Caliper axle cover; 5. Outer piston seal; 6. Piston; 7. Piston sealing ring; 8. Piston limiting ring; 9. Seal; 10. Shoe retainer; 11. Block; 12. Internal noise-absorbing plate; 13. Anti-noise plate; 14. Rubber cover; 15. Assembled caliper; 16. Caliper bracket; 17. Plug; 18. Disc
Removal
Attention! Calipers are changed in pairs per axle.
1. Raise the car and remove the wheels.
2. Close the hole of the brake hose nipple with a piece of rubber hose of a suitable diameter. Unscrew the nipple bolt and disconnect the brake hose.
3. Loosen the mounting bolts and remove the caliper.
 |  |
4. If necessary, remove the bracket from the steering knuckle or rear axle bracket by unscrewing the bolts indicated by the arrows. In the picture on the left is the front caliper bracket, on the right is the rear caliper bracket.
Installation
Installation is performed in reverse order. Tighten all bolts to the specified torque. Remove air from the brake hydraulic system.