Contents: Removal ↓ Installation ↓
Rear wheel hub parts with bearing assembly
1. Cylinder; 2. Brake disc; 3. Rear wheel hub with bearing; 4. Hub sealing ring; 5. Brake drum
Removal
Attention! The rear wheel hub with the bearing cannot be repaired and is replaced as a single unit.
1. Raise the rear of the car and place it on stands. Remove the rear wheel.
2. Remove the brake drum or disc (see subsection 10.6.).
This material is taken from a resource [toyotaman]
3. Unscrew the 4 bolts securing the hub housing to the suspension bracket through the holes in the hub flange. To access the bolts, the flange must be rotated.
4. Remove the hub assembly with the bearing.
5. Remove the hub seal ring.
Installation
1. Install the hub and align the holes in the hub body with the bolt holes in the brake shield. Tighten the bolts. It is convenient to use a magnet when installing bolts in threaded holes. Tighten the bolts to the specified torque.
2. Install the brake drum (or disc), caliper and wheel. Install the wheel and lower the car.