Pic. 2.92. Valve stem seals for intake and exhaust valves and their installation: 1 - special tool
Using the special tool 09201-41020, install new valve stem seals. Inlet valve stem seals painted black and exhaust valve stem seals grey (pic. 2.92).
Install the parts in the following order:
- 1 - valve;
- 2 - spring seat;
- 3 - spring;
- 4 - spring plate.
Pic. 2.93. Fitting a cotter around the valve stem: 1 - special tool; 2 - wooden bars
Using the special tool 09202-70020, compress the valve spring and install two cotters around the valve stem (pic. 2.93).
Pic. 2.94. Fixing the valve with crackers: 1 - insulating tape; 2 - valve stem
With a plastic-faced hammer and the stem of an unused valve wrapped in insulating tape, hit the end of the valve stem to ensure that the valve is securely fixed with crackers (pic. 2.94).
Install the valve lifters and make sure the lifters turn freely.
Install the camshaft position sensor with a tightening torque of 9 Nm.
Install the coolant temperature sensor with a tightening torque of 20 Nm.
Install the oil pressure switch by applying sealant to 2-3 threads with a tightening torque of 13 Nm.