Set the number one piston to TDC on the compression stroke.
Pic. 2.55. Combination of markings with marks on the camshaft bearing caps: 1 - marks on the covers; 2 - marking «0»
To remove the crankshaft pulley, turn it and align the mark with the mark «0» on the timing chain cover. Make sure that the marks on the sprockets are aligned with the marks on the caps No. 1 and No. 2 of the camshaft bearings, as shown in Figure 2.55.
Pic. 2.56. Removing the crankshaft pulley: 1 - puller
Loosen the pulley bolt with the special tool, then remove the crankshaft pulley with a puller (pic. 2.56).