- Tightening torque during installation - 49 Nm
2. Unscrew the tray mounting bolts.
Attention:
- Some amount of liquid always remains in the tray.
- Do not damage the filler tube.
- Tightening torque during installation - 8 Nm
3. Clean the tray from dirt.
Remove the magnets and use them to carefully collect all metal particles from the tray.
Based on the particles that have entered the sump, it is possible to determine which element of the gearbox is wearing out:
- steel particles (magnetic) - wear out: bearings, gears, and disks.
- brass particles (non magnetic) — bushings.
Note: When installing, make sure the magnets do not touch the oil pipes.
A140E, A140L
A540N
4. Remove the filter and tube bracket, a) Unscrew the three bolts and remove the filter.
[The original version is published on the website: www.ToyotaMan.ru]
Note: Bolt lengths (in mm) are shown in the figure.
- Tightening torque during installation - 10 Nm
A140E, A140L
A540N
Installation instructions (A540H): Install the gasket into the filter.
b) Unscrew the two bolts and remove the bracket.
- Tightening torque during installation - 10 Nm
