Attention: do not damage the speed sensor rotor (ABS).
2. Temporarily install the hinge covers on the shaft.
Note: before installation, wrap electrical tape around the splines of the drive shaft to prevent damage to the boot.
A) Temporarily install a new outer joint boot on the drive shaft
b) Temporarily install a new inboard joint boot on the drive shaft.
3. Install the triple pivot.
A) Rotate the triple joint with the splined chamfer towards the outer joint.
b) Align the alignment marks made before disassembly.
V) Using a copper rod and a hammer, press the triple joint onto the drive shaft.
Attention: do not drop the hinge when installing.
G) Using the special tool, install a new circlip.
4. Install the inner pivot race.
A) Apply grease to the inner joint race and boot.
Note: Use only grease designed for hinges when assembling.
- The amount of lubricant - 180 - 190 g
b) Align the alignment marks made before disassembly.
V) Install the cage on the shaft
5. Install boot straps.
A) Apply grease to the outer joint and boot.
Note: Use only grease designed for hinges when assembling.
- The amount of lubricant - 120 - 130 g
b) Check that the boots are in the grooves of the shaft.
V) Fasten the clamps.